Customers who bought this item also bought
Combined with CNC mount will allow you to fit your Rindow Bullet light to front or rear brake calipers.
The stainless silver stays come in two different types, straight or bent. Straight stay is recommended for the rear attachment as the light will be mounted at a higher position.
The CNC alloy mount that would allow you to fit your Rindow Bullet light to front or rear eyelets. This mount can also be used with the stainless stays to mount the lights to the front or rear brake calipers.
Rindow Bullet is a stylish and great quality light that will complement any bike. Made in Japan from high quality components it has a sleek aluminium CNC machined body and can be attached onto your handlebars or seat post with rubber strap or mounted above the brake calipers by adding a separate mount and stainless stay (supplied separately).
Front light has 40 lumens and 3 modes (high, low and flash). A USB charge cable is supplied and it will take 2.5hrs to fully recharge.
Rindow Bullet will last 3 hours on high, 6 hours on low and over 50 hours on flash mode.
These lights are waterproof (IPX 4) which means that they will be running even in the worst weather conditions.
CNC mounts and stays sold separately.
Cross Lever is an in-line brake lever designed for use on the flat upper section of drop handlebars. It can be used with short-pull or long-pull brakes and road bars.
By routing your existing brake cable and housing from your drop levers through the Cross Lever, you can have two sets of brake levers that allow you to control your speed from multiple hand positions.
Cross Lever fits onto the thicker stem clamp area of handlebars, and a hinged clamp allows for installation without needing to strip your bar tape.
Cross Lever can also be used on its own: Just let the head of brake cable sit in the recess for the housing on the outside of the lever. A barrel adjuster makes it easy to fine tune your cable tension.
Two versions are available to fit handlebars with a stem clamp area diameter of 26.0mm or 31.8mm. Additionally, the hinged clamp of a 26.0mm Cross Lever is designed in a way that also allows it to mount securely on handlebars with a 25.4mm diameter stem clamp area.
Fully CNC'd construction gives them a solid feel in the hand, and they are designed to work with any kind of brake. The Cross Lever is both a Short Pull and a Long Pull lever, depending upon the position of the adjustable pivot.
The levers come with their pivot pins in the hole closest to the handlebar. This location is for short pull brakes, like road calipers, centerpull cantilever brakes, and road mechanical disk brakes. Moving the pivot pin to the outer hole makes the levers compatible with long pull brakes, like Motolites, V-Brakes and mountain mechanical disk brakes.